Kit-Pro-Fap and Dpf: cleaning of particle filters in degraded mode
Notre traitement professionnel de décrassage des Filtres à Particules in mode dégradé (non régénération) est efficace pour nettoyer et restaurer les propriétés of parfaite combustion du bloc engine. In purgeant les impuretés de type boues ou suies noires, vous redonnez du couple au engine, polluez moins, roulez éco-propre.
Instructions for use Pro Kit FAP and Dpf
1 – Mix 250 ml of cleaner Kn-Fap with 750 ml of water.
2 – Disconnect the two hoses from the pressure sensor of the Fap.
3 – Inject the mixture with a pneumatic tool through the tubing, pressure sensor upstream (in front of the FAP) and leave on for between 20 and 30 minutes.
4 – then, run the engine outdoors at 2000 revolutions per minute or with an exhaust fan, cap tube "upstream" with a screw and a clamp.
5 – Blowing, and re-assemble the two tubes and erase engine fault with the bag technique.
6 – Pour 250 ml of Eco 10 000 Diesel in the tank with 25 litres of diesel.
7 – Drive the vehicle for a road in the mode of forced regeneration with the briefcase is connected, and the professional mechanic on board.
8 – When the vehicle can circulate in way not degraded, return to the workshop to disconnect the briefcase. Then, the driver must drive the vehicle (according to the advice of the mechanic, that vary depending on the brand and type of vehicle). Drive until the indicator of the fuel reserve (in multiple pathways, but not by more than four-lane highways or freeways) to clean the most of the FAP with Eco 10 000.
9 – Use Mécarun C 99 Diesel at each refuel with a double dose to prevent soiling the FAP, that no sludge or bacteria in the tank and save fuel.
The Eco 10 000 on the road by the driver.